Save and Load Tuning Files
One of the most exciting aspects of the EcmDroid app is that you can load a new ECM tuning file in seconds using an Android phone or tablet. You are no longer required to replace your ECM after installing performance upgrades like exhaust systems and high-flow air cleaners. Pre-made tuning files are available here and tuning software such as TunerPro and EcmSpy allow those with tuning knowledge to have complete control over their Buell ECM.
*Using tuning the above mentioned software for commercial use (e.g. selling tuning files) is a violation of the software licensing agreements and strictly prohibited. Buelltooth does not engage in, condone or encourage this activity. On the Links and Resources page you will find tuning guides and links to software manufacturers. Purchasing a software license and learning how to tune your own motorcycle is a rewarding process.
*Using tuning the above mentioned software for commercial use (e.g. selling tuning files) is a violation of the software licensing agreements and strictly prohibited. Buelltooth does not engage in, condone or encourage this activity. On the Links and Resources page you will find tuning guides and links to software manufacturers. Purchasing a software license and learning how to tune your own motorcycle is a rewarding process.
Prior to making any changes or adjustments to the ECM EEPROM file you must save your original so that you can revert back to it if needed.
The following screen shots are used as examples and may vary from one device to another.
*Ensure that "Show Hidden Files" is enabled in your file manager, otherwise you may not be able to see the EcmDroid folders and files.
- After establishing a connection with your ECM, select EEPROM Editor from the dropdown menu.
- Select the dropdown menu in the top right corner.
- Select "Save".
- Give this file a name that will identify it as your original EEPROM file, but do not change the first part of the file name that identifies the ECM firmware it matches with.
- Select OK.
The folder that this file was saved in is also where you must put the file you wish to burn on to your ECM. The following example is of an Android device that has EcmDroid installed on the internal storage.
- Open File Manager, then select "All Files".
- Open Internal Storage Folder (Or External Storage Folder if EcmDroid is installed on a memory card).
- Open the Android Folder
- Open the data folder.
- Open the org.ecmdroid folder.
- Open the files folder (you're almost there!)
- Open the EEPROM folder.
- Here is where you will find your saved file.
- Move the EEPROM file you wish to install from your Downloads folder into this same folder so that it will be recognized by EcmDroid.
To Burn the new tuning file onto your ECM, return to the EEPROM Editor page in EcmDroid.
- Select Load from the dropdown menu in top right corner.
- A list of files located in the EEPROM folder will appear. Select the file you wish to install onto the ECM.
- If required, select your ECM type. In this case it is BUE2D.
- Find and select the Burn icon. It may or may not be labeled, depending on your device.
- Pause and take a deep breath (for dramatic effect) and then select OK.
After writing of the EEPROM is complete it is necessary to perform a TPS reset. This procedure is here.
